Note both the primary error code and the accompanying sub-code or contextual data (e.g., floor number or drive state). 📋 Verified Schindler 5500 Error Code Matrix
Clear the sills. Manually cycle the door to check for friction points. Error 0402: Door Closing Failure Meaning: The doors could not fully close or lock. schindler 5500 error codes verified
The mechanical governor has detected car travel exceeding rated speeds, or the electrical contact on the governor assembly has opened due to cable slack or vibration. Note both the primary error code and the
| Code | Description | Likely Cause | |------|-------------|----------------| | | No active error | Normal operation | | 0101 | Door open time exceeded | Door motor weak, obstruction, or door lock faulty | | 0104 | Door close time exceeded | Obstruction, defective door operator, or bad clutch | | 0201 | Overload | Load weighing system triggered (over 110% of rated load) | | 0203 | Load weighing sensor fault | Defective LWG sensor or wiring | | 0302 | Car overspeed (inspection mode) | Speed encoder, brake slippage, or V3F25 drive issue | | 0305 | Drive overcurrent | Short circuit in motor windings, defective drive module | | 0401 | Position lost | Pulse encoder failure, missing magnets, or rope slip | | 0410 | Floor position error | Wrong floor table, missing NBT/NBB magnets | | 0501 | Brake not opening | Coil open circuit, power supply failure, or contactor stuck | | 0502 | Brake not closing | Brake sticking, spring tension wrong, or contactor welded | | 0603 | Door lock circuit failure | Door contact not made when expected (safety chain) | | 0704 | Shaft information error | Bad NBT (magnet) pattern, corrupted floor table | | 0805 | Emergency stop activated | Car switch, pit stop, or machine room stop pressed | | 0909 | Communication error to group | CAN bus fault between cars or to main controller | | 1010 | V3F25 drive fault | Drive internal error, overtemp, DC link high/low | | 1201 | Car lighting failure | Emergency light on, main lighting relay failed | | 1300 | Battery low (emergency lowering) | Battery needs replacement or charging circuit fault | Error 0402: Door Closing Failure Meaning: The doors