Galaxy Aqua Premier Installation Manual

Mark the fixing holes through the backplate onto the wall. Also, mark the entry points for the water pipe and electrical cable.

: Select a spot on the drain pipe away from the garbage disposal outlet. Position it well above the plumbing "P-trap." galaxy aqua premier installation manual

Open the kitchen faucet to completely bleed pressure from the line. Mark the fixing holes through the backplate onto the wall

| Problem | Possible Cause | Solution | | :--- | :--- | :--- | | | No power supply. | Check isolator switch and main fuse. | | | Thermal cut-out activated. | Reset the thermal cut-out button (located behind the cover). | | Water not hot enough | Temperature dial set too low. | Increase temperature setting. | | | Incoming water very cold. | Increase flow rate or temperature setting. | | Water too hot / Steam | Water flow rate too low. | Increase water flow at the tap. | | | Blockage in inlet filter. | Isolate water, remove and clean filter. | | Leakage | Loose connections. | Tighten fittings and check washers. | Position it well above the plumbing "P-trap

Attach the flexible supply hose from your cold water supply line to the "INLET" port of the Galaxy Aqua Premier. Connect the second flexible hose from the "OUTLET" port to your downstream plumbing or dispensing faucet. Tighten the connections firmly with an adjustable wrench, but avoid over-tightening, which can crack the fittings. Step 6: Install Cartridges or Components