Proteus 8 Professional Tutorial ((full)) Online

Place your resistors, capacitor, and LED in a similar fashion.

Click the button (Pick Devices) in the Component Selector pane. proteus 8 professional tutorial

Click and drag on the screen to draw a yellow rectangle. This defines the physical boundaries of your PCB. Step 3: Placing Components Place your resistors, capacitor, and LED in a

Click the destination pin to complete the connection. Tip: To place a manual bend in a wire, click once on any empty space on the canvas while routing. Step 5: Power, Ground, and Bus Terminals This defines the physical boundaries of your PCB

Adjust the timebase and voltage knobs on the pop-up panel to clearly see the square wave pulsing across the screen. 5. Microcontroller (MCU) and Firmware Simulation

Click the icon on the left toolbar (it looks like a small voltmeter meter). Here you will find: