Crawford Cdm9 950 Installation Manual <2027>

Secure the torque arm to the wall or track bracket to prevent the motor from rotating. Step 3: Engaging the Manual Disconnect Locate the red and green pull cords (or lever).

Before you begin, ensure your site and door meet the operator's requirements: Standard handles up to 400 kg ; the HD version supports up to 800 kg . Power Supply: 230V AC, single phase, 50/60Hz. Drive Speed: Approx. 0.25 m/s for standard opening. crawford cdm9 950 installation manual

If the door only operates in "hold-to-run" mode, it typically indicates a fault with the torque guard , encoder , or control card memory . Secure the torque arm to the wall or

Wire external safety beams to stop the door if the beam is broken. 🔄 4. Limit Switch Adjustment Power Supply: 230V AC, single phase, 50/60Hz

Setting the limits tells the operator exactly where the door should stop when opening and closing. inside the operator cover. Move the door manually to the fully closed position. Adjust the "Close" cam until it clicks the microswitch. Move the door manually to the fully open position.

: The operator is designed for a 35 mm hexagonal shaft . Fit the first stop ring onto the pivot, place the adapter, and push the drive unit onto the shaft.